Setting Of The Terminating Resistor Selection Switch - Mitsubishi Electric 800 Series Instruction Manual

2.3

Setting of the terminating resistor selection switch

Always set the terminating resistor selection switch (refer to
resistor (refer to page 27) to the inverter that is the end station (FR-A8NC) in advance.
The following table lists the specifications of the terminating resistor selection switch.
(In the initial setting, no terminating resistor is set (1: OFF and 2: OFF).)
Setting 1 2
OFF OFF
ON OFF
OFF ON
ON ON
20
INSTALLATION
Without terminating resistor (initial setting)
Do not use.
130 Ω (resistance value with the CC-Link Ver. 1.00 dedicated high performance
cable)
110 Ω
page 8) or connect the one-touch connector plug with terminating
Description