Setting The Parameters On Gx Works2; Parameter Setting Screen - Mitsubishi Electric M800VS Series Connection And Set Up Manual

M800VS/M80V Series Connection and Setup Manual
20 Sequence Program Writing

20.5 Setting the Parameters on GX Works2

20.5 Setting the Parameters on GX Works2
Note
(1) There are two methods of ladder programming; independent program method and multi-program method, which makes
differences in parameter settings. An incorrect parameter setting in the ladder programming may cause a write error.
For details of the parameter settings, refer to the "PLC Development Manual".

20.5.1 Parameter Setting Screen

(1) Displaying the parameter setting screen
To open the parameter setting screen, display the project view on the navigation window by the following operation.
Expand the tree by double-clicking [Parameter], and double-click [PLC Parameter].
[Project] -> Double-click [Parameter] -> Double-click [PLC Parameter]
The above operation opens the following parameter setting screen. Tab names in red indicate that the initial values are
set.
PLC parameter
Project view
427 IB-1501613-A