Control Unit Connection System Drawing - Mitsubishi Electric M800VS Series Connection And Set Up Manual

M800VS/M80V Series Connection and Setup Manual
7 Connection of Control Unit

7.1 Control Unit Connection System Drawing

The method for connecting to each unit and device from the control unit is explained in this chapter.
7.1 Control Unit Connection System Drawing
Control unit
DCIN
EMG
LCD
BL
MENUKEY
[FCU8-DX731/DX750/DX760/DX761]
CJ71
[FCU8-DX834]
CJ71
For M800VS
RIO1/RIO2
For M80V
RIO1/RIO2
For M800VS
OPTH1/OPTH2
For M80V
OPTH1
SIO
SKIP
ENC
LAN1/LAN2
Note
(1) The mounted connector differs depending on the unit. Refer to the following chapter for which of the connector is
mounted.
"4.3 Control Unit [M800VS]" 4.4 Control Unit [M80V]
(2) For connection to the machine operation panel, refer to the chapter "13 Connection of Machine Operation Panel".
IB-1501613-A
J070/J071 cable
J120
cable
Attached cable of unit
Attached cable of unit
Attached cable of unit
J010 cable
J012 cable
J210 cable
J210 cable
Select
J395/J396/G380 cable
J395/J396/G380 cable
J030/J031 cable
J100 cable
R050/R054 cable
J026/J027 cable
J303 cable
24VDC Stabilized
power supply
Emergency stop signal
Display unit
Operation panel I/O unit
CJ71
Operation panel I/O unit
RIO3
Remote I/O unit
Remote I/O unit
Pulse-controlled inverter
Servo/Spindle drive unit
Servo/Spindle drive unit
RS-232C device
Skip input (Sensor input)
Synchronous feed encoder, or
5V manual pulse generator
Network
218