Mitsubishi Electric M800VS Series Connection And Set Up Manual page 262

M800VS/M80V Series Connection and Setup Manual
7 Connection of Control Unit
7.6 Connecting with Drive Unit
When using together with the MDS-E/EH unit
The power (L+, L-) can be supplied to the additional axis drive unit by using the power supply part which is built into MDS-EM/
EMH. For the additional axis unit receiving power (L+,L-) from the MDS-EM/EMH unit, the optical cable must be connected at
the NC side of the MDS-EM/EMH unit.
When using MDS-EM and MDS-E drive units in combination
MDS-E-V1
5th axis
Connected
to the NC
Optical
communication
cable
The optical communication cables from the NC to the
final drive unit must be within 30m.
When using MDS-EM drive unit together with MDS-E
CAUTION
There is a limit to the combination of the drive unit.
Refer to "7.3 Selection of the Additional Axis Drive Unit" in "MDS-EM/EMH Series Specifications Manual".
MDS-E-SP2 MDS-E-SP
6th/7th axis 8th axis
231
MDS-EM-SPV3
Spindle:1st axis
Servo:2nd/3rd/4th axis
TE2
IB-1501613-A