Setting The Number Of Common Pointer Points - Mitsubishi Electric M800VS Series Connection And Set Up Manual

M800VS/M80V Series Connection and Setup Manual
20 Sequence Program Writing
20.5 Setting the Parameters on GX Works2

20.5.3 Setting the Number of Common Pointer Points

In the following cases, set the pointer No. common to sequence programs.
 When creating the sequence programs with the multi-program method
 When creating sequence programs of main process with ST language
This operation is required every time a new project is created, and parameter files must be written to the CNC controller.
Note
 When common pointer No. is not set, "P1800" is set.
When a simple project (with labels) or a structured project is newly created, or when "Project Type" is changed to any of the
said project, "2048" is automatically set to "Common Pointer No." as the default value if its setting has been blank.
(1) Select the [PLC System] tab.
(2) Set a numeric value in [Common Pointer No.], and click [End] on the following screen.
429 IB-1501613-A