Writing Sequence Program Using The Sd Card; Setting The Ethernet Communication; Confirming The Ip Address For Cnc; Setting The Ip Address For Pc Side - Mitsubishi Electric M800VS Series Connection And Set Up Manual

Hide thumbs Also See for M800VS Series:

Table of Contents

M800VS/M80V Series Connection and Setup Manual

20 Sequence Program Writing

20.1 Writing Sequence Program using the SD Card

Sequence program writing is executed by connecting a personal computer, in which GX Developer or GX Works2 has been

installed, to the control unit.

For details of GX Works2,.refer to the "PLC Development Manual"

For details of GX Developer, refer to instruction manuals and specifications manuals related to GX Developer which are listed

in "Manual List".

20.1 Writing Sequence Program using the SD Card

Save the sequence program in an SD card and write the data to NC using the external file operations on PLC onboard.

Confirm the IP address set for the CNC. IP address is set to the following parameter.

Basic common parameter

The case of when the initial value "192.168.200.1" after SRAM clear has been set is explained as an example in this chapter.

For the personal computer for which GX Developer or GX Works2 is available, IP address has to be set within the same

subnet mask as CNC unit.

(1) Select [Start] - [Control Panel] - [Network and Internet] - [Network and Sharing Center] from task bar.

(2) "Network and Sharing Center" is displayed. Click [Local Area Connection].

IB-1501613-A

Global IP address

IP address for CNC seen from an external source

Global Subnet mask

Subnet mask of #1926

Setting example

192.168.200.1

255.255.255.0