Relation With Other Functions - Mitsubishi Electric M800VS Series Connection And Set Up Manual

M800VS/M80V Series Connection and Setup Manual
29 Deceleration Check

29.5 Relation with Other Functions

29.5 Relation with Other Functions
 Tool compensation
When the tool compensation is performed, the deceleration check will be operated on the block after compensation.
 Control axis synchronization (G125), control axis superimposition (G126), arbitrary axis exchange (G140), arbitrary axis
superimposition (G156)
When control axis synchronization (G125), control axis superimposition (G126), arbitrary axis exchange (G140) or
arbitrary axis superimposition (G156) is performed in the other part system, the succeeding block start timing may be
delayed in the cutting block to which the axis related to these functions belongs.
 Automatic error detect
The deceleration check is invalid in the block with the automatic error detect ON, the block complete condition follows the
automatic error detect.
 High-speed machining mode
When in high-speed machining mode, if the axis movement reverses to the opposite direction in a G01 to G01 successive
block, the commanded deceleration will not be performed even with G1Ipfg set to "1".
When the axis movement reverses to the opposite direction in G01 to G00 successive block, it follows the setting of
G0Ipfg.
 High-speed simple program check
The deceleration check is performed during the high-speed operation in the high-speed simple program check also. The
deceleration check time is reduced according to the time reduction coefficient during the high-speed simple program
check operation.
 Deceleration check in polar coordinate interpolation/milling interpolation/cylindrical start/cancel command
The deceleration check in polar coordinate interpolation/milling interpolation/cylindrical start/cancel command are as
follows.
Parameter: #1223 aux07 BIT1
0
1
IB-1501613-A
Deceleration check method
Command deceleration check
In-position check
528