Mitsubishi Electric M800VS Series Connection And Set Up Manual page 463

M800VS/M80V Series Connection and Setup Manual
20 Sequence Program Writing
20.6 Writing a Sequence Program with GX Works2
 If an attempt is made to remove the check from parameter and write sequence programs while a PLC is running, the
message shown below is displayed.
"Your PC is running. Force the file to be written?"
The CNC only supports writing during RUN from the [Compile] menu; if [Yes] is clicked, an error dialog is displayed and
sequence programs are not written.
Click [No] and then click [Yes] when the following message is displayed:
"Perform a remote stop and write to PC?"
IB-1501613-A 432