Connecting With Skip Signal (Sensor) - Mitsubishi Electric M800VS Series Connection And Set Up Manual

Hide thumbs Also See for M800VS Series:

Table of Contents

M800VS/M80V Series Connection and Setup Manual

7 Connection of Control Unit

7.9 Connecting with Skip Signal (Sensor)

Connect the skip signals to SKIP connector of the control unit.

Skip signals are used for processing high-speed signals. Always shield the cable.

Control unit

(1) Connecting the skip signal cable to a wrong connector causes a damage on the control unit when turning ON the skip sig-

nal power supply. Confirm the wiring before turning the power ON.

Connection of skip signal cable

 0 V connections at COM terminal

Control unit

0V connection at COM terminal

IB-1501613-A

power supply