Mitsubishi Electric M800VS Series Connection And Set Up Manual page 12

[Transportation and installation]
CAUTION
Correctly transport the products according to the mass.
Use motor's suspension bolts to transport the motor itself. Do not use it to transport the motor after instal-
lation onto the machine.
Do not stack the products exceeding the indicated limit.
Do not hold the cables, shaft or encoder when transporting the motor.
Do not transport the controller or drive unit by suspending or holding the connected wires or cables.
Do not hold the front cover when transporting the unit. The front cover could come off, causing the unit to
drop.
Install on a non-combustible place where the unit's or motor's mass can be withstood according to the in-
struction manual.
The motor does not have a complete water-proof (oil-proof) structure. Do not allow oil or water to contact
or enter the motor. Prevent the cutting chips from being accumulated on the motor as they easily soak up
oil.
When installing the motor facing upwards, take measures on the machine side so that gear oil, etc., will not
enter the motor shaft.
Do not remove the encoder from the motor. (The encoder installation screw is treated with sealing.)
Do not allow foreign matter to enter the controller, drive unit or motor. Take particular care to avoid allowing
any conductive foreign matters such as screws or metal chips, or combustible foreign matters such as oil
to enter. Failure to observe this could result in rupture or damage.
Do not get on the product or place heavy objects on it.
Provide prescribed distance between the controller/drive unit and inner surface of the control panel/other
devices.
Do not install or operate the controller, drive unit or motor that is damaged or has missing parts.
Take care not to cut hands, etc. with the heat radiating fins or metal edges.