Table of Contents
Advertisement
1.
Put the front border cover (A) against the front of the Power Cabinet.
2.
Put the rear border cover (B) against the rear of the Power Cabinet.
3.
Put the side border covers (D) against the sides of the Power Cabinet.
4.
Insert the M5 bolts (C) into the holes (8x).
5.
Tighten the bolts.
5.6. Connect AC power cable and GND wires Power Cabinets
5.6.1. Remove the protection covers
Preconditions:
Tools: cross-head screwdriver
1.
Remove the protection plate (A) by loosening the screws (B).
2.
Put the protection plate and screws in a safe location as it will be installed again later
on.
Document: V1.2 / Document No.: 6AGA000008-0629-EN | Date: 06-30-2022
HVC‐PD E‐Bus Charger Installation Guide
Page 66 of 146
Advertisement
Table of Contents
