Table of Contents
Advertisement
5.6.4. Install the protection covers
Preconditions:
Tools: cross-head screwdriver
1.
Take the 3 protection covers that was removed in Remove the protection covers on Page
66.
2.
Place the protection covers (D) back on the connector blocks (C).
3.
Take the protection plate and the screws that were removed in Remove the protection
covers on Page 66.
4.
Place the protection plate (A) back over the main switch and connector blocks and
secure the plate by the screws (B).
Document: V1.2 / Document No.: 6AGA000008-0629-EN | Date: 06-30-2022
HVC‐PD E‐Bus Charger Installation Guide
Page 70 of 146
Advertisement
Table of Contents
