Table of Contents
Advertisement
5.15.3.
Pantograph Z-axis angle adjustment
The pantograph can be adjust for road inclination (Z-axis) between the 0º and 6.0º, see also
section Maximum slope of the road in Z-axis on Page 35.
The angle setting of the pantograph is done by twisting the pantograph over its suspension
system.
1.
Loosening M12 nuts (A) (4x) on both side of the two V-shape bolts (C) so the pantograph
can rotate freely.
Don't remove the nuts (A) of the two U-bolts (C). Otherwise the
pantograph can fall down.
2.
Loosening lock nuts (C) (2x) on both side of the locking bolts (B).
3.
Turn both bolts (B) outwards (but do not remove those), so that the pantograph can freely
rotated.
4.
Adjust the pantograph with help of the included level tool in the correct angle position.
5.
Tighten the locking bolts (B) (2x) hand tight until the bolts hit the stopper plate (D). In this
way the locking bolts (B) locked the pantograph in the right angle position.
6.
Tighten lock nuts (C) (2x).
7.
Tighten M12 nuts (A) (4x).
Document: V1.2 / Document No.: 6AGA000008-0629-EN | Date: 06-30-2022
HVC‐PD E‐Bus Charger Installation Guide
WARNING
Page 102 of 146
Advertisement
Table of Contents
