Table of Contents
Advertisement
1. Introduction
1.1. Preface
This guide describes the planning and physical installation of the HVC-PD E-Bus Charger with
a "fold-out" charge Pole at its location.
The HVC-PD E-Bus Charger is a DC fast charger system for hybrid or electrical buses that
are compatible with the OPP Charging standard
Charger to charge any other equipment, or to use the HVC-PD E-Bus Charger for any other
purposes.
The HVC-PD E-Bus Charger uses high-amperage electric currents. Therefore the installation
must be planned carefully, and must be done by certified personnel only (according to local
standards
2
).
Before installing the HVC-PD E-Bus Charger, read this Installation Guide carefully and
attentively. Follow the instructions in this Installation Guide. ABB is not responsible for
any damage that has been caused by not or incorrectly following and executing the
instruction described in this manual.
1.2. Intended document users
This document is intended to be used by:
Customers who purchased a HVC-PD E-Bus Charger, or are in the process of ordering
and want to know in more detail how it has to be installed.
Contractors who are responsible for site preparation and/or installation of the HVC-PD
E-Bus Charger.
1.3. Signs
The following signs are used on the equipment and in this manual:
Hazardous voltage
Identifies a hazard that could result in severe injury or death through
electrocution.
Various
Identifies a hazard that could result in severe injury or death.
Rotating parts
Identifies a hazard that could result in injury due to the presence of
rotating or moving parts.
1
More information on OPP Charge via www.oppcharge.org.
2
Local regulations shall take precedence if they list different installation requirements than prescribed in this Installation
Manual.
1
. It is not permitted to use the HVC-PD E-Bus
DANGER
WARNING
WARNING
Advertisement
Table of Contents
