Install The Protection Cover; Connect Ac Utility Power, Interlock And Can Cables Power Cabinet; Route The Cables To The Terminal Blocks - ABB HVC-PD Installation Manual

5.7.2. Install the protection cover

1. Take the protection plate that was removed in Remove the protection covers on Page 74.
2. Place the protection plate (A) back over the DC connector blocks and secure the plate by
the screws (B) (4x).

5.8. Connect AC utility power, Interlock and CAN cables Power Cabinet

Preconditions:

Tools: wire cutter, wire stripper pliers, screwdriver, ferrules, crimp pliers.
Make sure that the main switch of the power supply group for the product
is set to the OFF position. Do a voltage check to make sure that the
electrical power is disconnected from the system. Secure against
resetting.

5.8.1. Route the cables to the terminal blocks

Document: V1.2 / Document No.: 6AGA000008-0629-EN | Date: 06-30-2022
HVC‐PD E‐Bus Charger Installation Guide
DANGER
Page 75 of 146