Gland Layout Of The Acs Control Module - ABB HVC-PD Installation Manual

7. Screw at the back side of the lighting protection connection a toothed washer (D) and a
nut (F) on the bolt (C).
8. Tighten the bolt with a tightening torque of 11 ft-lb.
5.16.4.

Gland layout of the ACS Control Module

Gland # Clamping range ØF
1 5 – 10 mm (0.20 – 0.39 Inch)
2 5 – 10 mm (0.20 – 0.39 Inch)
3 5 – 10 mm (0.20 – 0.39 Inch)
4 5 – 10 mm (0.20 – 0.39 Inch)
5 10 - 17 mm (0.39 – 0.67 Inch)
6 5 – 10 mm (0.20 – 0.39 Inch)
7 5 – 10 mm (0.20 – 0.39 Inch)
8 5 – 10 mm (0.20 – 0.39 Inch)
9 5 – 10 mm (0.20 – 0.39 Inch)
10 10 - 17 mm (0.39 – 0.67 Inch)
11 13 – 21 mm (0.51 – 0.83 Inch)
12 13 – 21 mm (0.51 – 0.83 Inch)
13 13 – 21 mm (0.51 – 0.83 Inch)
14 27 – 35 mm (1.07 – 1.38 Inch)
15 27 – 35 mm (1.07 – 1.38 Inch)
16 27 – 35 mm (1.07 – 1.38 Inch)
17 27 – 35 mm (1.07 – 1.38 Inch)
18 27 – 35 mm (1.07 – 1.38 Inch)
19 27 – 35 mm (1.07 – 1.38 Inch)
20 27 – 35 mm (1.07 – 1.38 Inch)
21 27 – 35 mm (1.07 – 1.38 Inch)
22 10 - 17 mm (0.39 – 0.67 Inch)
Document: V1.2 / Document No.: 6AGA000008-0629-EN | Date: 06-30-2022
Cable
AC utility power
Pantograph heater
Interlock
Pantograph CP/PE
RFID Ethernet
EMO switch
Beacon
Not used
Temperature sensor
RFID Power cable
Communication (fibers)
ACS Control
PE (GND)
DC+ In (from HVC 150, primary)
DC+ In (from HVC 150S, secondary 1)
DC+ Out (to pantograph)
DC+ Out (to pantograph)
DC+ Out (to pantograph)
Not used
DC+ In (from HVC 150S, secondary 2)
Not used
DC- OVP Sensing
HVC‐PD E‐Bus Charger Installation Guide
Page 106 of 146