Table of Contents
Advertisement
5.5.6. Install border covers of the Power Cabinet
Preconditions:
Tools: torx screwdriver (size 2163TX-T30).
M5 bolts (8x) that were removed from the Power Cabinet (bag with parts).
1.
Put the front cover (A) against the bottom front of the Power Cabinet by aligning the four
bolts at the back side of the front cover (A) with the holes in the bottom front.
2.
Put the rear cover (B) against the rear front of the Power Cabinet.
3.
Insert the M5 bolts (C) into the holes (8x).
4.
Tighten the bolts.
5.5.7. Install border covers of metal frame foundation
Only applicable when the Power Cabinet is placed on a metal frame
foundation. The supplied front and rear cover on the Power Cabinet are
not used in this case.
Preconditions:
Tools: torx screwdriver (size 2163TX-T30)
Document: V1.2 / Document No.: 6AGA000008-0629-EN | Date: 06-30-2022
HVC‐PD E‐Bus Charger Installation Guide
NOTICE
Page 65 of 146
Advertisement
Table of Contents
