Connect The Gnd Wire Of The Ac Power Cable - ABB HVC-PD Installation Manual

3. Remove the 3 protection covers (D) from the connector blocks (C).
4. Put the protection covers in a safe location as it will be installed again later on.

5.6.2. Connect the GND wire of the AC power cable

Preconditions:

Tools: wire cutter, wire stripper pliers, cable lug, spanner (size 19), torque wrench (size
19).
Make sure that the main switch of the power supply group for the product
is set to the OFF position. Do a voltage check to make sure that the
electrical power is disconnected from the system. Secure against
resetting.
Document: V1.2 / Document No.: 6AGA000008-0629-EN | Date: 06-30-2022
HVC‐PD E‐Bus Charger Installation Guide
DANGER
Page 67 of 146