Table of Contents
Advertisement
1.
Route the WiFi cable (A) to the WiFi connector (B).
2.
Insert the WiFi type N-plug into the WiFi connector (B).
3.
Hand tighten the WiFi plug.
5.16.11.
Connect the RFID cables
This section is not required if the RFID module is not present.
Preconditions:
Tools: wire cutter, wire stripper pliers, screwdriver, ferrules, crimp pliers.
1.
Loosen and remove the cable gland's (#5 and #10) nuts for the RFID Ethernet and the
RFID Power cables respectively.
2.
Slide the cable gland's nuts over the RFID Ethernet and RFID Power cable.
3.
Route the RFID Ethernet cable through gland #5 to module U10 (A).
4.
Insert the RJ45 connector (B) of the Ethernet cable into the Ethernet port X2 of module
U10 (A)
5.
Tighten the nut of the gland to secure the RFID Ethernet cable.
Document: V1.2 / Document No.: 6AGA000008-0629-EN | Date: 06-30-2022
HVC‐PD E‐Bus Charger Installation Guide
NOTICE
Page 113 of 146
Advertisement
Table of Contents
