Labrie EXPERT Maintenance Manual page 98

88 General Maintenance
Figure 3-100 Marking down arm stopper location
2.
Remove both side panels (one on each side of the hopper).
N : If a tipper is installed on the side panel, you will have first to remove it before removing the side
OTE
panel.
Figure 3-101 Side panel
3.
Remove the lower part of both side rails (one on each side of the hopper) by using a 5/16-inch
Allen wrench and a 3/4-inch wrench (see Figure 3-194).
There are 6 bolts in total on each side.
N : In order to get access to the last of the 6 bolts that hold the lower part of the side rail in place,
OTE
remove the midway flashing lights located on each side of the truck.