Labrie EXPERT Maintenance Manual page 57

Follow these steps before proceeding with the removal of the packer panel:
1.
Start the engine and engage the hydraulic pump.
2.
Fully raise the crusher panel (if installed).
3.
Using the joystick, extend the automated arm to get better access to the hopper area.
Danger!
Secure the area around the path of the automated arm when performing maintenance
or repair.
4. Fully retract the packer by pressing the yellow button on the packer control station.
Danger!
Do not enter the hopper while the packer is moving.
5.
Turn OFF the hydraulic pump and the engine.
6.
Lock out and tag out the vehicle (see Locking Out and Tagging Out the Vehicle on page 14).
NEXT: ACCESSING PACKER: See "A. Accessing Packer - Standard Units W/ Loading Arm" on
page 50.
B. Preparing Packer for Removal - Standard Units W/O Loading Arm
Follow these steps before proceeding with the removal of the packer panel:
1. Start the engine and engage the hydraulic pump.
2. Fully raise the crusher panel (if installed).
3. Fully extend the packer, then push the red emergency
fully extended position.
Danger!
Do not enter the hopper while the packer is moving.
4. Turn OFF the hydraulic pump and the engine.
5. Lock out and tag out the vehicle (see Locking Out and Tagging Out the Vehicle on page 14).
NEXT: ACCESSING PACKER: See "B. Accessing Packer - Standard Units W/O Loading Arm" on
page 52.
C. Preparing Packer for Removal - Co-Mingle - W/ Loading Arm
Follow these steps before proceeding with the removal of the packer panel:
1.
Start the engine and engage the hydraulic pump.
General Maintenance 47
button to maintain the packer in its
STOP