Labrie EXPERT Maintenance Manual page 168

158 General Maintenance
Figure 3-222 Hopper rear side
Remove the cotter pin (see Figure 3-223) that holds the cylinder pin in.
9 g.
Figure 3-223 Chute cylinder and related parts
Plate
holding bolt
Pillow block
Plate
Chute shaft
Remove the cylinder pin that secures the cylinder rod to the chute lever (see Figure 3-223).
9 h.
N : Take care not to cause misalignment of the limit switch when disconnecting the chute-
OTE
operating cylinder.
If needed, retract the chute-operating cylinder. To do so:
9 i.
Protective cover
Grease
fitting
Cotter pin
Crusher panel
deflector
Crusher panel
Plate
holding bolt
Hydraulic hoses
Chute lever
Chute cylinder