Labrie EXPERT Maintenance Manual page 192

182 General Maintenance
Figure 3-263 Packer and follower panels
Remove both rollers (one on each side of the top follower panel).
10 b.
Using a 5⁄16-inch Allen wrench and a 3⁄4-inch box, remove all 4 bolts that keep the roller in
place (see Figure 3-264).
Figure 3-264 Removing bolts
Bottom
panel
Packer
Install new rollers to replace the ones that have been removed.
10 c.
Put back all 4 bolts in their respective holes before tightening them up.
Flip the bottom follower panel backward (panel next to packer) [see Figure 3-263].
10 d.
The two follower panels are now folded over the packer.
Remove both rollers (one on each side of the bottom follower panel).
10 e.
Using a 5⁄16-inch Allen wrench and a 3⁄4-inch box, remove all 4 bolts that keep the roller in
place (see Figure 3-264).
Install new rollers to replace the ones that have been removed.
10 f.
Packer
Bottom follower panel
RHS roller retaining bolts
Top
panel
LHS roller retaining bolts
Top follower panel
Roller