Labrie EXPERT Maintenance Manual page 95

Figure 3-95 Marking down arm stopper location
2.
Remove both side panels (one on each side of the hopper).
Figure 3-96 Side panel
N : If a tipper is installed on the side panel, you will have first to remove it before removing the side
OTE
panel.
3. Remove the lower part of both side rails (one on each side of the hopper) by using a 5/16-inch
Allen wrench and a 3/4-inch wrench (see Figure 3-194).
There are 6 bolts in total on each side.
N : In order to get access to the last of the 6 bolts that hold the lower part of the side rail in place,
OTE
remove the midway flashing lights located on each side of the truck.
General Maintenance 85