Labrie EXPERT Maintenance Manual page 61

Figure 3-25 R-pin holding anti-spill guard in place
2. Remove the deflector panel.
Use a ¾-inch wrench to remove the 4 bolts that hold the panel.
Figure 3-26 Deflector panel
3.
Remove the transversal beam by taking out the 4 bolts (2 on each side) that retain it.
Figure 3-27 Transversal beam
4.
Remove the upper part of both side rails (one on each side of the hopper) [see Figure 3-28].
4 bolts are to be taken out to remove this section of the side rail.
General Maintenance 51