Labrie EXPERT Maintenance Manual page 155

2. Using the joystick, extend the automated arm to get better access to the hopper area.
Danger!
Secure the area around the path of the automated arm when performing maintenance
or repair.
3.
Fully retract the packer.
Danger!
Do not enter the hopper while the packer is moving.
4. Turn OFF the hydraulic pump and the engine.
5. Lock out and tag out the vehicle (see Locking Out and Tagging Out the Vehicle on page 14).
6. Open the left/right hand side hopper door.
7. Remove the anti-spill guards located on each side of the hopper (see Figure 3-196).
An R-pin located just behind the anti-spill guard (see Figure 3-197) must be pulled completely to
allow for the removal of the guard.
Figure 3-196 Anti-spill guard
General Maintenance 145