Labrie EXPERT Maintenance Manual page 207

Figure 3-289 Pillow blocks
5.
Using a lifting device, lift the body just enough to be able to tilt the safety prop under the body.
The cylinder will remain in place.
Ensure that the cylinder remains in vertical position while lifting the body.
I :
MPORTANT
6.
Install the safety prop.
7.
Lower the body on the safety prop.
8.
Using a lifting device, remove the body hoist cylinder carefully.
Save both pillow blocks for the replacement cylinder (see Figure 3-289).
9.
Place the pillow blocks that were set aside on the pins of the new cylinder.
10.
Using a lifting device, install the new body hoist cylinder on the base support and reinstall both
base pillow blocks.
11. Put back all 4 bolts and tighten them up to hold both base pillow blocks in place (see Figure
3-288).
12.
Using a lifting device, extend the cylinder in order to fix it properly to the body.
Removing the plug on the top of the cylinder before extending it is required to avoid a vacuum.
I :
MPORTANT
General Maintenance 197