Labrie EXPERT Maintenance Manual page 185

D. Co-Mingle Units W/O Loading Arm
To replace a worn-out lower wear pad, apply the following procedure:
1.
Start the engine and engage the hydraulic pump.
2.
Fully retract the packer using the yellow button on the packer control station.
Danger!
Do not enter the hopper while the packer is moving.
3.
Turn OFF the hydraulic pump and the engine.
4.
Lock out and tag out the vehicle (see Locking Out and Tagging Out the Vehicle on page 14).
5. Remove the anti-spill guards located on each side of the hopper (see Figure 3-250).
An R-pin located just behind the anti-spill guard (see Figure 3-251) must be pulled completely to
allow for the removal of the guard.
Figure 3-250 Anti-spill guards
Figure 3-251 R-pin holding anti-spill guard in place
6.
Remove the hopper divider (see Figure 3-252).
General Maintenance 175