Labrie EXPERT Maintenance Manual page 100

90 General Maintenance
Figure 3-103 Plastic wiper blade
3.
Reinstall all parts that have been removed by applying the following procedures in reverse order:
A. Removing Packer Panel - Standard Units W/ Loading Arm on page 81, A. Disconnecting Packer -
Standard Units W/ Loading Arm on page 73 and A. Accessing Packer - Standard Units W/ Loading
Arm on page 50.
4. Once finished re-assembling the removed components, lubricate and check for proper operation
of the packer.
: If the packer moves vertically by more than 3/16", the upper wear pads must be replaced or
N
OTE
adjusted (see Upper Wear Pads on page 135 and Replacing and Adjusting Upper Wear Pads on
page 163).
B. Installing New Packer - Standard Units W/O Loading Arm
To install a new packer:
1. Using a lifting device, lower the new packer into the hopper, properly aligning the packer with the
floor guides.
2.
Install a new wiper blade on each side of the packer (see Figure 3-104).
These wiper blades may require to be adjusted with shims to reduce the play between the blades
and the packer (see Figure 3-104 and Figure 3-257).