Labrie EXPERT Maintenance Manual page 412

404 Lifting Arms
Figure 10-34 Bolts in lower row
Replacing Green Wear Pads
N : For units equipped with a long reach H
OTE
When green wear pads are worn out, they have to be replaced.
To replace worn-out green wear pads, carry out the following procedure:
1. Fully extend the H
2. Use an appropriate device to secure the arm.
3. Remove the packer scraper (or lower wear pad) to access the T-track retaining bolts (8).
See Lower Wear Pad on page 165.
4.
Remove the T-track bolts and take the T-track out through the opening created by the removal of
the packer scraper.
Figure 10-35 T-track
5.
Replace the T-track wear pads.
As dust particles and sand stick to grease, never lubricate the H
I :
MPORTANT
pads. If you do, this may jam the moving parts and/or cause premature wear.
6. Open the doghouse on the streetside.
ELPING
-H ™ automated arm.
ELPING AND
-H ™ arm only.
AND
T-track
retaining
bolts
T-track
-H
ELPING AND
™ automated arm wear