Labrie EXPERT Maintenance Manual page 66

56 General Maintenance
2. Remove the hopper divider (see Figure 3-36).
There are 6 bolts that hold the divider to the packer panel. These bolts are to be taken out to
remove the hopper divider. A 5/8" nut located at the rear end of the divider must also be taken
out (see Figure 3-38).
Figure 3-36 Hopper divider
Figure 3-37 Bolts holding divider (6)
Figure 3-38 5/8" nut
3.
Remove the divider guard.
4 bolts are to be taken out to remove the divider guard (2 on each end).