Labrie EXPERT Maintenance Manual page 230

220 General Maintenance
Move the chute so that it rests on the left rubber bumper.
2 b.
Danger!
Fully lower the right-hand side crusher panel.
2 c.
Turn OFF the hydraulic pump and the engine.
2 d.
Lock out and tag out the vehicle (see Locking Out and Tagging Out the Vehicle on page 14).
2 e.
Remove the right-hand side protective cover (see Figure 3-317).
2 f.
Exit the hopper.
2 g.
Start the truck and engage the hydraulic pump.
2 h.
Fully raise the right-hand side crusher panel.
2 i.
Move the chute so that it rests on the right rubber bumper.
2 j.
Fully lower the left-hand side crusher panel.
2 k.
Turn OFF the hydraulic pump and the engine.
2 l.
Lock out and tag out the vehicle (see Locking Out and Tagging Out the Vehicle on page 14).
2 m.
Remove the left-hand side protective cover (see Figure 3-317).
2 n.
Figure 3-316 Hopper rear side
: Once the protective covers are removed, you will be able to access the area where the chute
N
OTE
cylinder and both chute limit switches are.
N : If one of the protective panels cannot be removed because one of the crusher panels is not
OTE
operational due to a limit switch not being triggered, you can still reach both limit switches
through the opening left by the removal of the other panel.
3. Verify the rod of the left-hand side chute limit switch touches its target, that is the chute pivot
(see Figure 3-315).
Never enter the hopper while the hydraulic system is engaged.
Protective cover
Crusher panel
deflector
Crusher panel