Labrie EXPERT Maintenance Manual page 46

36 General Maintenance
N : If no right-hand side packer control station is installed, you may use the Crusher Panel Up
OTE
switch on the in-cab control panel (see Figure 3-4). Keep this switch pressed until the panel is
raised completely.
7. Push the green S
red emergency S
8.
Lock out and tag out the vehicle (see Locking Out and Tagging Out the Vehicle on page 14).
9.
Open both hopper doors.
10.
Slowly open the clean-out trap door on both sides of the hopper.
Caution!
The clean-out traps may contain a certain amount of liquids, mainly water that seeps
from garbage during collection work. Be careful not to let these liquids fall on bare skin
and/or get into the eyes.
N : Keep the clean-out trap doors open while cleaning the hopper.
OTE
Figure 3-11 Clean-out trap door
11.
Clean all accumulated dirt under the cylinders and inside the side rails (see Figure 3-8) through
the clean-out traps using the provided hoe (see Figure 3-9). Use pressurized water if necessary.
Caution!
Avoid spraying pressurized water directly on connectors and battery fuses.
12.
Rake small pieces of garbage out of the clean-out traps.
C button (see Figure 3-7) to fully extend the packer, then push the
TART YCLE
button (see Figure 3-7) when the packer is fully extended.
TOP