Labrie EXPERT Maintenance Manual page 118

108 General Maintenance
Figure 3-132 Chute cylinder and related parts
Plate
holding bolt
Pillow block
Plate
Chute shaft
N : The above illustration is used only to show where the parts are located and how they are
OTE
attached to each other.
20. Remove the pins that hold the cylinder rods in place (see Figure 3-132).
N : Take care not to cause misalignment of both limit switches when disconnecting the two chute-
OTE
operating cylinders.
Figure 3-133 Location of both chute-operating cylinders
21.
If needed, retract both chute-operating cylinders. To do so:
Grease
fitting
LHS chute cylinder
Plate
holding bolt
Hydraulic hoses
Chute lever
Cotter pin
RHS chute cylinder
Chute cylinder