Labrie EXPERT Maintenance Manual page 76

66 General Maintenance
Figure 3-57 Hopper rear side
Remove the cotter pin (see Figure 3-58) that holds the cylinder pin in.
4 g.
Figure 3-58 Chute cylinder and related parts
Plate
holding bolt
Pillow block
Plate
Chute shaft
Remove the cylinder pin that secures the cylinder rod to the chute lever (see Figure 3-58).
4 h.
N : Take care not to cause misalignment of nearby both limit switches when disconnecting the
OTE
chute-operating cylinder.
If needed, retract the chute-operating cylinder. To do so:
4 i.
Protective cover
Grease
fitting
Cotter pin
Crusher panel
deflector
Crusher panel
Plate
holding bolt
Hydraulic hoses
Chute lever
Chute cylinder