Labrie EXPERT Maintenance Manual page 114

104 General Maintenance
N : On some trucks, especially those with a single split crusher panel, the crusher panel deflector
OTE
also needs to be removed (see Figure 3-127).
Figure 3-127 Hopper rear side
Once the protective cover is removed, you will be able to access the area where the chute cylinder
is.
7.
Remove the cotter pin (see Figure 3-132) that holds the cylinder pin in.
8.
Remove the cylinder pin that secures the cylinder rod to the chute lever (see Figure 3-132).
N : Take care not to cause misalignment of the limit switch when disconnecting the chute-
OTE
operating cylinder.
9. Release the cylinder rod from the chute lever by pulling it up gently (see Figure 3-128).
Figure 3-128 Adjusting chute cylinder
10.
Loosen the locknut to allow manual adjustment of the chute cylinder.
Protective cover
Cylinder
Crusher panel
deflector
Crusher panel
Cylinder
Locknut
rod
Rod head
Chute lever