Labrie EXPERT Maintenance Manual page 136

126 General Maintenance
2. Slide the cylinder into position behind the packer through the clean-out trap.
Caution!
3.
Align the cylinder with the front pin hole.
Figure 3-166 Cylinder aligned with front pin hole
4.
Reinstall the front cylinder pin and its 4 bolts (see Figure 3-162).
5. Tighten all 4 bolts.
6. Reconnect both hoses to the cylinder fittings. To do so:
Place a bucket under the hoses to collect oil that may spill out.
6 a.
Remove the caps from the hoses and connect the hoses to the appropriate fittings.
6 b.
Be careful to reconnect hoses to proper fittings. Use the identification method from Step 7
of the preceding procedure to help you with this task.
Tighten both cylinder hose fittings.
6 c.
Figure 3-167 Tightening hose fittings
This task must be performed by 2 people.
Front pin hole