Labrie EXPERT Maintenance Manual page 384

376 Multiplexing
Table 5 Allison transmission programmed parameters
PTO Drive Interface 1: Maximum Engine Speed for Engagement
PTO Drive Interface 1: Maximum Engine Speed for Operation
PTO Drive Interface 1: Maximum Output Speed for Engagement
PTO Drive Interface 1: Maximum Output Speed for Operation
N : Engine speed (RPM) or road speed (MPH) limiters are options.
OTE
Table 6 Allison wires to be enabled
Pack enable
Input
PTO
Output
PTO
Output neutral indicator – PTO
Auto-neutral pack enable (if present)
To tap into the TCM, Labrie uses the following wires on the Allison connector:
Table 7 Input
Wire #
117
143
142
Parameters (PTO Enable)
Wires
enable
enable
Description
Pump pack enable
P enable
TO
Auto-neutral pack input
Wire # (WTEC IV)
117
143
130
145
142
Active when the brakes are used, and when the PTO and
auto-neutral switches are ON (ground signal).
Active when the PTO switch is ON (+12­V signal).
Active when the brakes are used, and when the PTO and
auto-neutral switches are ON (ground signal).
RPM
900
4000
5000
5000
State