Labrie EXPERT Maintenance Manual page 167

Figure 3-220 Chute
N : The E ™ may be equipped with a dual split crusher panel, or a single split crusher panel
XPERT
OTE
which would be located either on the right-hand side or on the left-hand side of the hopper
(see Figure 3-23).
Turn OFF the hydraulic pump and the engine.
9 d.
Lock out and tag out the vehicle (see Locking Out and Tagging Out the Vehicle on page 14).
9 e.
Remove both protective panels that are fixed to the rear hopper wall (see Figure 3-221).
9 f.
Figure 3-221 Protective panels
: On some trucks, especially those with a single split crusher panel, the crusher panel deflector
N
OTE
also needs to be removed (see Figure 3-222).
Once the protective covers are removed, you will be able to access the area where the chute
cylinder and the rear end section of the chute shaft are.
General Maintenance 157