6 Assembly - Olympus SZ2-ILA Instructions Manual

6
Assembly
The modules shown in the following figure are merely the typical examples. For other applicable modules that are not
given below, please consult your Olympus representative or the latest catalogues.
When assembling the microscope, make sure that all parts are free of dust and dirt, and avoid
NOTE
scratching any parts or touching glass surfaces.
Stage glass
SP-C
ø 45 mm
frameless filter
Filter holder
Place the SZ2-ST Place the SZ2-ST
on the SZ2-ILA, pull on the SZ2-ILA, pull
the SZ2-ST toward the SZ2-ST toward
the front until it is the front until it is
stopped, and tighten stopped, and tighten
the clamping knob. the clamping knob.
Standard stand
SZ2-ST
Clamping knob
(Clamping using a coin)
For the connection of cables and power cord, and the assembly of light guide illumination system, see
TIP
the instruction manual provided separately.
Simplified
polarization system
SZ-POL-2
(Polarizer)
Clamping screw
( Clamping using the allen
wrench provided with the
microscope body. ) microscope body. )
Lamp housing adapter
SZ2-LHAD
Transmitted illumination
attachment SZ2-ILA
Clamping screw
(For use only with the SZ2-LHAD)
Simplified
polarization system
SZ-POL-2
(Analyzer)
Power supply
BX3M-PSLED
LED lamp housing
BX3M-LEDT
Collector lens
SZ2-LGCL
Transmitted light
guide adapter
SZ2-TLGAD
To power outlet
SZ2-ILA
SZ2 series
microscope body
Dust protection filter
SZ-FIL
To power
Flexible light guide
SZ2-CLGSF
Light guide illuminator
SZ2-CLS
outlet
7