Config: Intfc1: Hssi: Tx: Rts/Cts; Config: Intfc1 (For Asi Interface Only) - Comtech EF Data CDM-710 Installation And Operation Manual

CDM-710 Broadcast Satellite Modem
Front Panel Operation

Config: Intfc1: HSSI: Tx: RTS/CTS

Intfc1 CTS/RTS:
Normal Fault
Select Normal or Fault using the
RTS is the same as TA and CTS is the same as CA. The selections operate as follows:
Normal: CTS = RTS
Fault: CTS = RTS when no fault is present. CTS is not asserted when a fault is present.
5.3.1.6
Intfc2 ASI:
Tx Rx
This menu tree shows what is presented if Interface 1(the Interface in Slot 1) is populated with
the ASI Interface. The following specified menu would depend on the installed interface.
Tx
If is selected:
Intfc1 ASI Tx:
Ena/Dis Frame ( E)
If Ena/Dis is selected:
Intfc1 ASI Tx:
Enable Disable
Selecting Enable or Disable activates or deactivates the Tx side of this interface. Disabling the
Tx side deactivates it and sets the data rate to 0.
If Frame is selected:
Intfc1 ASI Tx Frame:
188 204
The user should select either 188 or 204 to enable either the 188 sync mode or the 204 sync
mode.
If Rx is selected:
Intfc1 ASI Rx:
Ena/Dis Frame ( E)
If Ena/Dis is selected:

arrow keys. The user should then press [ENTER].

Config: Intfc1 (For ASI Interface Only)

Config ( E)
( E)
( E)
5–39
Revision 9
MN/CDM710.IOM