Comtech EF Data CDM-710 Installation And Operation Manual page 184

CDM-710 Satellite Modulator
Remote Control
Command
Parameter (Instruction for Command
Type Code and
Qualifier)
Gigabit Primary GSP= 2 bytes
Stream
Gigabit Stream GSM= 2 bytes
Mode
Gigabit Stream GTO= 3 bytes
Timeout
Gigabit Stream GTM= 2 bytes
Timeout Mode
Initialize IEP= None
Events Pointer
Boot Image IMG= 1 byte
Arguments
Description of Arguments
or Response
to Query
Gigabit Primary Stream
s=Slot (1, 2)
m=Multicast Stream (1, 2)
Gigabit Stream Mode
s=Slot (1, 2)
m=Mode
1=Single Stream
2=Dual Stream (Redundancy Mode)
Gigabit Stream Timeout (Only used when in Dual Stream Mode).
s=Slot (1, 2)
t=Timeout in 100 mS intervals (0 – 10)
Gigabit Stream Timeout Mode (Only used when in Dual Stream
Mode)
s=Slot (1, 2)
m=Mode
0 = Non-revertive
1 = Revertive
***When in redundancy mode (GSM = 1 ), this parameter
controls whether the Gigabit Interface switches back and forth
between the two input streams for a valid MPEG stream.
Revertive means the interface will switch back and forth between
the two streams. Non-revertive is a latching scheme where the
interface will only switch to the secondary stream.
Resets internal pointer to allow RNE? queries to start at the
beginning of the stored events log.
Boot image selection, where n is the image number:
1=Image #1
2=Image #2
Example: IMG=1 (Selects Image #1 for booting.)
Response
to
Command
GSP=
GSP#
GSP?
GSP*
GSM=
GSM#
GSM?
GSM*
GTO=
GTO#
GTO?
GTO*
GTM=
GTM#
GTM?
GTM*
IEP=
IEP#
IMG=
IMG?
IMG*
IMG#
A–22
Revision 9
MN/CDM710.IOM
Query
(Instruction
Response to Query
Code and
Qualifier)
GSP?s GSP=sm
GSM?s GSM=sm
GTO?s GTO=stt
GTM?s GTM=sm
N/A N/A
IMG? IMG=n