CDM-710 Broadcast Satellite Modem
Summary of Specifications
8.9
Remote Port Operation
Description
Comtech EF Data
Remote Port
Ethernet Telnet
Ethernet SNMP
Ethernet HTTP
8.10 Data Rate Range
Symbol Rate and Data Rate Range for DVB-S2, DVB-S and DVB-DSNG. There is some round off in the
data rate ranges in the last digit. The first table is for the standard FEC frame and the second table is for the
short frame. DVB recommends turning the Pilot ON for 8PSK and higher modulation orders, particularly
when phase noise is present. These modes may need Pilot ON may need the Pilot ON for low C/N
operation: 8PSK 1/2, 16APSK 2/3 and 3/4, and 32APSK 3/4 to assist carrier recovery. QPSK 1/4, 1/3, and
2/5 data is for information only.
Requirements
See remote port chapter.
Ethernet transport of standard Remote Control commands.
See SNMP Chapter
Support all control and monitor parameters.
8–10
Revision 9
MN/CDM710.IOM
Need help?
Do you have a question about the CDM-710 and is the answer not in the manual?
Questions and answers