Comtech EF Data CDM-710 Installation And Operation Manual page 202

CDM-710 Satellite Modulator
Remote Control
Command Arguments
Parameter (Instruction for Command
Type Code and or Response
Qualifier) to Query
Description of Arguments
c=Rx Traffic Status
0=No faults
1=+1.5V Demod Power Supply Unit (Demodulator Card)
2=FPGA Load (Demodulator Card)
3=Demod Unlocked
4=DSNG Sync Error
5=FPGA Temperature (Demodulator Card)
6=BER Limit Exceeded
7=AGC Level Out of Range
8=Eb/No Limit Exceeded
9=Demodulator Synth 1 PLL
A=Demodulator Synth 2 PLL
B= SERDES Demod to Framer
C= SERDES Framer to FEC1
D= SERDES Framer to FEC2
E= Demod FAST options not installed.
F= MPEG transport stream error.
G=ASI Rx PLL Empty (Interface 1)
H=ASI Rx PLL Full (Interface 1)
I=ASI Rx PLL Lower Limit Reached (Interface 1)
J=ASI Rx PLL Upper Limit Reached (Interface 1)
K=ASI Rx PLL Empty (Interface 2)
L=ASI Rx PLL Full (Interface 2)
M=ASI Rx PLL Lower Limit Reached (Interface 2)
N=ASI Rx PLL Upper Limit Reached (Interface 2)
O=Rx DCM Unlocked
P=ASI Rx SERDES Error (Interface 1)
Q=ASI Rx SERDES DCM Unlocked (Interface 1)
R=ASI Rx SERDES Error (Interface 2)
S=ASI Rx SERDES DCM Unlocked (Interface 2)
T=HSSI Rx Buffer Underrun (Interface 1)
U=HSSI Rx Buffer Overflow (Interface 1)
V=HSSI Rx Buffer Underrun (Interface 2)
W=HSSI Rx Buffer Overflow (Interface 2)
X=Framer SERDES Rx Fault (Interface 1)
Y=Framer SERDES Rx Fault (Interface 2)
Z=Rx Clock Source Fault (Interface 1)
[=Rx Clock Source Fault (Interface 2)
A–41
d=New Faults
0=No new faults
1=New faults, since last check
MN/CDM710.IOM
Query
Response
(Instruction
to Response to Query
Code and
Command
Qualifier)
Revision 9