Gef; Geg; Gep; Gfm - Comtech EF Data CDM-710 Installation And Operation Manual

CDM-710 Satellite Modulator
Remote Control
Command
Parameter (Instruction for Command
Type Code and
Qualifier)
Firmware N/A 1 byte
Revisions
Gigabit Egress

GEF=

2 bytes
FEC Enable
Gigabit Egress

GEG=

16 bytes
Multicast
Group Address
Gigabit Egress

GEP=

11 bytes
Port Numbers
Gigabit Egress

GFM=

6 bytes
FEC Matrix
Arguments
Description of Arguments
or Response
to Query
Query the version information of the system. Where:
i = Bulk Image number (1 or 2)
a = Firmware Image
b = Firmware Revision
c = Firmware Date
Example: FRW?1
Gigabit Egress FEC Enable/Disable.
s=Slot (1, 2)
n=Enable / Disable, where
0 = Disabled
1 = Enabled
Gigabit Egress Multicast Group Address. The multicast stream
egressing from the gigabit interface will have this ip address as
the source IP address.
s=Slot (1, 2)
i=IP Address
Gigabit Egress Port Numbers
s=Slot (1, 2)
nnnnn = Source Port Number (0 – 65535)
ppppp = Destination Port Number (0 – 65535)
*** Note: Both Source Port and Destination Port must be valid
for set command to take effect.
Gigabit Egress FEC Matrix.
s=Slot (1, 2)
ll = Length, two digit number (leading zero) between 1 and 20.
dd = Depth, two digit number (leading zero) between 4 and 20.
**( Length x Depth, must be less than or equal to 100 )
Response
to
Command
FRW?
FRW*
FRW#
GEF=
GEF#
GEF?
GEF*
GEG=
GEG#
GEG?
GEG*
GEP=
GEP#
GEP?
GEP*
GFM=
GFM #
GFM?
GFM*
A–42
Revision 9
MN/CDM710.IOM
Query
(Instruction
Response to Query
Code and
Qualifier)
FRW?i FRW={CR}Boot:{CR}a,
b,c{CR}Bulki:{CR}a,b,c
{CR}a,b,c...
GEF?s GEF=sn
GEG?s GEG=siii.iii.iii.iii
GEP?s GEP=snnnnnppppp
GFM?s GFM=sll,dd