Comtech EF Data CDM-710 Installation And Operation Manual page 183

CDM-710 Satellite Modulator
Remote Control
Command
Parameter (Instruction for Command
Type Code and
Qualifier)
Firmware N/A 1 byte
Revisions
Gigabit FEC GFE= 2 bytes
Enable
Gigabit FEC GFP= 6 bytes
Base Port
Gigabit GIP= 19 bytes
Management IP
Address and
Subnet
Gigabit GMI= 17 bytes
Multicast
Address
Gigabit Active N/A 2 bytes
Stream
Gigabit Source GSI= 17 bytes
IP Address
Arguments
Description of Arguments
or Response
to Query
Query the version information of the system. Where:
i = Bulk Image number (1 or 2)
a = Firmware Image
b = Firmware Revision
c = Firmware Date
Example: FRW?1
Enables the Gigabit FEC mode.
s=Slot (1, 2)
n=Enable/Disable
0=Disabled
1=Enabled
Gigabit FEC Base Port number
s=Slot (1, 2)
n=Port Number (0 – 65535)
Gigabit Management IP address and subnet mask.
s=Slot (1, 2)
i=IP Address
n=Netmask
Gigabit Multicast Address
s=Slot (1, 2)
m=Multicast Stream (1, 2)
i=IP Address
Gigabit Active Stream
s=Slot (1, 2)
m=Stream (1, 2)
Gigabit Source IP Address
s=Slot (1, 2)
m=Multicast Stream (1, 2)
i=IP Address
Response
to
Command
FRW?
FRW*
FRW#
GFE=
GFE#
GFE?
GFE*
GFP=
GFP#
GFP?
GFP*
GIP=
GIP#
GIP?
GIP*
GMI=
GMI#
GMI?
GMI*
GSA=
GSA#
GSA?
GSA*
GSI=
GSI#
GSI?
GSI*
A–21
Revision 9
MN/CDM710.IOM
Query
(Instruction
Response to Query
Code and
Qualifier)
FRW?i FRW={CR}Boot:{CR}a,
b,c{CR}Bulki:{CR}a,b,c
{CR}a,b,c...
GFE?s GFE=sn
GFP?s GFP=snnnnn
GIP?s GIP=siii.iii.iii.iii.nn
GMI?sm GMI=smiii.iii.iii.iii
GSA?s GSA=sm
GSI?sm GSI =smiii.iii.iii.iii