Config: Intfc1: Hssi: Tx: Enable; Config: Intfc1: Hssi: Rx; Config: Intfc1: Hssi: Rx: Data; Config: Intfc1: Hssi: Rx: Datarate - Comtech EF Data CDM-710 Installation And Operation Manual

CDM-710 Broadcast Satellite Modem
Front Panel Operation

Config: Intfc1: HSSI: Tx: Enable

Intfc1 Tx Enable:
Enable Disable
Select Enable or Disable, using the
selection is use to activate and deactivate the Tx side of this interface.
Disabling the Tx side deactivates it and changes the data rate to 0.

Config: Intfc1: HSSI: Rx

Intfc1 Rx:
Data Buffer
Select Data, Buffer, Clock or Enable, using the
[ENTER].

Config: Intfc1: HSSI: Rx: Data

Intfc1 Rx Data:
Datarate
Select Datarate or Invert, using the

Config: Intfc1: HSSI: Rx: Datarate

Intfc1 Data Rate:
Rx: 032.000000 Mbps
This is a status only message indicating the data rate of the received MPEG-2 transport stream.
(E)

Clock Enable
Invert (E)

arrow keys. The user should then press [ENTER]. This
(E)

arrow keys. The user should then press
arrow keys. The user should then press [ENTER].
5–36
Revision 9
MN/CDM710.IOM