Comtech EF Data CDM-710 Installation And Operation Manual page 240

CDM-710 Satellite Modulator
Remote Control
If HSSI interface, then format is:
Note: The following codes are used in the 'Response to Command' column:
= Message ok
? Received ok, but invalid arguments found
* Message ok, but not permitted in current mode
# Message ok, but unit is not in Remote mode
a = Tx Data Inversion
b = Rx Data Inversion
c = Tx Clock Inversion
d = Rx Clock Inversion
e = Rx Clock Source
ff.f = Rx Buffer Size
same as TDI (omit interface slot parameter)
same as RDI (omit interface slot parameter)
same as TCI (omit interface slot parameter)
same as RCI (omit interface slot parameter)
same as RCK (omit interface slot parameter)
same as RBS (omit interface slot parameter)
A–79
Revision 9
MN/CDM710.IOM