Config: Intfc1 (Cdi-60 Hssi); Config: Intfc1: Hssi: Tx - Comtech EF Data CDM-710 Installation And Operation Manual

CDM-710 Broadcast Satellite Modem
Front Panel Operation
5.3.1.5
The menus are shown for the HSSI Interface installed in Slot1. The CDM-710 supports a single
HSSI Interface (Intfc1).
Intfc1 HSSI:
Tx Rx CTS/RTS
There is a single port on a CDI-60 HSSI Interface. Select Tx, Rx or CTS/RTS, using the

arrow keys. The user should then press [ENTER].

Config: Intfc1: HSSI: Tx

Intfc1 Tx
Data Clock Enable
Select Data, Clock or Enable, using the
GBEI Statistics Summary
Mng Jabber (In) – Total frames received form the local GBEI management
processor with a length greater than the maximum size of octets but with an
invalid FCS
Mng Rx Err (In) – Total frames received from the local GBEI management
processor for which an error was detected by its physical interface
Mng FCS Err (In) – Total frames received from the local GBEI management
processor with a CRC error which was not counted in the Fragments or Rx Err
totals
Mng Octets (Out) – The sum of the lengths of all Ethernet frames transmitted to
the local GBEI management processor
Mng Unicast (Out) – The sum of frames transmitted to the local GBEI
management processor that have a unicast destination MAC address
Mng Broadcast (Out) – The sum of frames transmitted to the local GBEI
management processor that have a broadcast destination MAC address
Mng Multicast (Out) – The sum of frames transmitted to the local GBEI
management processor that have a multicast destination MAC address

Config: Intfc1 (CDI-60 HSSI)

(E)
(E)

arrow keys. The user should then press [ENTER].
5–34
Revision 9
MN/CDM710.IOM