Comtech EF Data CDM-710 Installation And Operation Manual page 146

CDM-710 Broadcast Satellite Modem
1000 Base-T (GbE) Interface
7. Transfer the files.
8. Verify the file transfer.
a. The PC should report that the file transfer has occurred.
b. Terminate the FTP session by typing "bye" and closing the DOS window.
c. Verify that the new file loaded using the procedure in Step 1.
9. After waiting at least 5 minutes you must cycle power on the modem for the new
GBEI firmware to run.
Type "put FW12547*.bin bulk:" to begin the file transfers. The destination
"bulk:" must be all lower-case.
It will take approximately ten minutes to transfer the file – wait for this
transfer to take place before proceeding to the next step.
Do NOT interrupt the transfer process. If the transfer process
is interrupted, the GbEI may have to be returned to the
manufacturer.
IMPORTANT
11–8
Revision 9
MN/CDM710.IOM